4.5.2 Dome Protocol Setup
The Dome Protocol item lists the available dome protocols for communicating with dome
cameras connected to the DVR. From the Main menu, select <Camera Setup> and press ENTER.
The following menu is displayed.
Analog Camera
1. Analog Camera Select
2. Dome Protocol
3. Dome ID
4. Camera Title
5. Covert
6. Termination
7. Brightness
8. Contrast
9. Saturation
10. Hue
CH1
None
0
CH1
No
Yes
0
0
0
0
To configure dome protocol, select a camera first and set the communications protocol
associated with dome camera using the Direction keys and ENTER. The available protocol
includes <DSCP>, <AD422>, <Pelco D>, <Pelco P>, <Fastrax 2>, <JVC>, <Panasonic_C>,
<Panasonic_N>, and <None>.
NOTE:
The settings become effective after saving the changes and exiting from the
menu.
4.5.3 RS485 Setup
The DVR controls the dome cameras via RS-485 communication protocol. The RS-485
parameters of the DVR must be set to the same as the parameters set in dome camera.
Users are allowed to change the RS-485 settings of the DVR. Select <System Setup> in
Main menu, then select <RS485 Setup> from the System Setup menu and press ENTER. The
following menu is displayed.
RS485 Setup
1 Unit ID
2 Baud Rate
3 Bits
4 Stop
5 Parity
224
9600
8
1
None
The ID number must match the ID address set by the dome. The Unit ID is in the range of 1
to 255. Note that there cannot be any two devices on the same bus given the same ID address, or
a conflict may occur.
NOTE:
The settings become effective after saving the changes and exiting from the
menu.
-
45
-
