Planar DOME Md5/DFP, Руководство по установке

Страница: 91 / 112

Configuring Display Settings | 79
To program the default display mode
You can use a display controlled by another display board to
program the default display mode for your Md5/DFP board.
This table shows the default and optional display modes for the
Md5/DFP board. You can set a new default display mode by
selecting optional display mode T or Z.
Use the
video_mode
command to program an optional display
mode as the new default display mode. For example, if you want
to program mode T on the first head of the first board in the
system, type this command:
video_mode -d /dev/md5dfp0.0 -m T
Display Mode Resolution
U
a
a. Default setting.
1536x2048
T 2048x1536
Z 2048x2560
All DIP switches on switch S2 must be set to OFF for the default
display mode to take effect. If they are not, switch S2 overrides
the default display mode programmed on the board. (See
“DIP switch S2 setting” on page 70.) DOME strongly
recommends that you use the default display mode.
After entering the
video_mode
command, you must reboot the
system for the new default display mode to take effect.