Preparing for Board Installation |
11
To support VGA with another VGA board
If you are using another board to support VGA display, you must
disable VGA mode on the Md5/DFP board.
Slide the DIP switches on switch S1 into the positions shown in
this table.
DIP Switch S1
Position
1
ON
2
OFF
3
ON
4
ON
When you install the Md5/DFP board into a computer with
an existing VGA board, you can use only one of the boards
to support the Windows NT operating system. You can run
Windows NT on either board, but you cannot run Windows NT
on both boards simultaneously.
Содержание DOME Md5/DFP
