Pitney Bowes F767, Руководство оператора

Страница: 33 / 66

SDC927D
2-17
Operation • 2
Once a program is selected and material loaded,
the F767 is controlled
by the DI900/DI950 Inserting System's control panel. Use the DI900/
DI950 controls to run a Trial Piece and to start and stop continuous
operation.
If the F767 is running an OMR program, three blocks will show on the
display as illustrated below. When running non-OMR jobs, blocks 2 and 3
only will show on the display.
Running the
System
JOB1 PAPER/DF C=1 ORIENTATION 3
Count: 00 Total: 000000 R Speed: 100%
Block 1
Block 2
Block 3
Block 1 shows that the F767 has read the first scan dash mark on the
page, indicating that the scanning system is functioning.
Block 2 shows that the F767 has confirmed to the Inserter that the
collation on the conveyor is ready for transfer into the
Inserter.
Block 3 indicates that the Inserter has sent back a collation signal to
the F767.
The F767 will continue operation until:
• You stop it by pressing
Stop/Clear Deck (Red).
or
• You open one of the covers. The safety interlock switch will stop the
machine.
or
• The material runs out or stalls. In this case the machine will stop
automatically.
TIP:
At the completion of each job run, it is recommended that you check the
two trays in the F733 Outsort Tray for diverted sets.