4-19
Virus SW 121
Pilot Operating Handbook
POH-121-00-40-001
PAGE REV. 0
PAGE
SECTION
4
NORMAL PROCEDURES
Actual touchdown should be made with power idle and on the main wheels
first to reduce the landing speed and subsequent need for braking. Gently
lower the nose wheel to the runway after airplane speed has diminished.
This is especially important for rough or soft field landings.
Short Field Landing
For a short field landing in smooth air conditions, make an approach at 60
KIAS with full flaps and fully extended airbrakes using enough power to con-
trol the glide path (slightly higher approach speeds should be used under
turbulent air conditions). After all approach obstacles are cleared, progres-
sively reduce power to reach idle just before touchdown and maintain the
approach speed by lowering the nose of the airplane. Touchdown should
be made power idle and on the main wheels first. Immediately after touch-
down, lower the nose wheel and apply braking as required. For maximum
brake effectiveness, retract the flaps, hold the control stick full back, and
apply maximum brake pressure without skidding. Keep airbrakes open until
reaching taxi speeds.
Crosswind Landing
Normal crosswind landings are made with (+1) flaps. Avoid prolonged slips.
After touchdown, hold a straight course with rudder and brakes as required.
The maximum allowable crosswind velocity is dependent upon pilot capabil-
ity as well as aircraft limitations. Operation in direct crosswinds of 18 knots
has been demonstrated.
Max Crosswind Component:
18 Kts
4.11 BALKED LANDING
In a balked landing (go around), apply full power and pitch up (climb), then
close airbrakes, then reduce the flap setting to (+1). If obstacles must be
cleared during the go around, climb at 57-60 KIAS with (+1) flaps. After clear-
ing any obstacles, retract the flaps and accelerate to the normal climb speed.
1
Throttle Lever
Check Full Forward
2
Airbrakes
Close
3
Flaps
(+1)
4
Airspeed
57 - 60 KIAS
Содержание Virus SW 121
