8-11
Virus SW 121
Pilot Operating Handbook
POH-121-00-40-001
PAGE REV. 0
PAGE
SECTION
8
HANDLING AND SERVICING
1
Flush away loose dirt with water
2
Apply cleaning solution with a soft cloth, a sponge or a soft bristle
3
To remove exhaust stains, allow the solution to remain on the surface
4
To remove stubborn grease, use a cloth dampened with degreaser or
naphtha.
5
Rinse all surfaces thoroughly.
Any good silicone free automotive wax may be used to preserve paint-
ed surfaces. Soft cleaning cloths or a chamois should be used to prevent
scratches when cleaning or polishing. A heavier coating of wax on the lead-
ing surfaces will reduce the abrasion problems in these areas. Pledge spray
is recommended to be applied once the surface is clean and can be used
instead of waxing.
Windscreen and Windows
Before cleaning lexan surfaces, rinse away all dirt particles before applying
cloth or chamois. Never rub dry lexan. Do not attempt to polish lexan.
CAUTION:
Clean windshield and windows only with a solvent free, none
abrasive, antistatic cleaner. Do not use gasoline, alcohol, benzene, carbon
tetrachloride, thinner, acetone, or glass window cleaning sprays. Use only
a nonabrasive cotton cloth or genuine chamois to clean acrylic windows.
Pledge spray is, however, recommended to be applied once the windshield
is clean.
NOTE:
Wiping with a circular motion can cause glare rings. Use an up and
down wiping motion to prevent this. To prevent scratching from dirt that has
accumulated on the cloth, fold cloth to expose a clean area after each pass.
1
Remove grease or oil using a soft cloth saturated mild detergent,
then rinse with clean, fresh water.
2
Using a moist cloth or chamois, gently wipe the windows clean of all
contaminates.
3
Dry the windows using a dry nonabrasive cotton cloth or chamois.
Engine Compartment
NOTE:
Only to be cleaned by licensed service personnel.
Содержание Virus SW 121
