Pioneer Eclipse PE320AS, Руководство по эксплуатации

Страница: 10 / 84

MACHINE PREPARATION
4. HOW TO MOVE THE MACHINE
1. To safely move the machine, you should use a pallet to support it (positioning
wooden wedges to block the wheels, as shown in the previous paragraph).
2.
Lower the squeegee by means of the lever at the rear of the machine. To assemble
the squeegee, read the “ASSEMBLING THE SQUEEGEE” paragraph.
4. Lower the base allowing the brushes to rest by means of the lever on the right rear of
the machine.
5.
Stop the machine by operating the brake lever located behind the left wheel of the
machine.
5. INSERTING/CONNECTING THE BATTERIES (B-BT versions)
The machine may be supplied with batteries and a built-in battery charger.
If batteries other than those supplied with the machine are used, have the battery
charger and battery control card configuration checked by a qualified, COMAC-trained
technician.
Perform a battery charging cycle before using the machine.
The batteries must be housed in the special compartment beneath the recovery tank.
To insert the batteries you must:
1. Engage the machine's parking brake.
2. Lower the squeegee and base. (see the appropriate chapter)
3. Release the hinges (1) on the handlebars.
4. Rotate the recovery tank as far as it will go, using the side handle (2).
5. Lift the batteries by means of the grips on the upper part.
6. House the batteries in the compartment, positioning the poles “+” and “-“ opposite
each other.
7. Check that the machine's master switch is in the "OFF" position.
8. Connect the batteries in series - using the supplied jumper cable (3) - to the poles “+”
and “-“.
9. Connect the battery connector cable to the terminal poles “+” and “-“ to obtain a
voltage of 24V on the terminals.
2
ATTENTION: you are advised to use airtight batteries only, to avoid
the leakage of acids!
ATTENTION: you are advised to have the electric connections
made by a qualified, APEC-trained technician.
ATTENTION: you are advised to always wear protective gloves, to
avoid the risk of serious injury to your hands.
ATTENTION: You are advised to only lift and move the batteries
with lifting and transportation means suitable for the specific weight
and size.
1
3
9