Appendix
Entwicklungshandbuch / Developer Manual PikoEval
Seite / Page 97 / 98
Version 8
4.2.3
Pin Assignment CAN 2 Development unit / Standard unit
1
6
5
10
Figure 22: Pin Assignment CAN2 Development unit / Standard unit
Pin 1
GND
Pin 2
Reserved
Pin 3
CAN high
Pin 4
CAN low
Pin 5
Power ground (out)
Clamp 31
Pin 6
12 VDC (out, optional)
Pin 7
Clamp 15R (out, optional)
Pin 8
Ignition (24V, out, max. 100mA)
Clamp 15
Pin 9
Reserved
Pin 10
24 VDC (out, max. 5A)
Clamp 30
Note: Ignition is 24 VDC !
Note: This CAN has a 120 Ohm terminating resistor!
The power supply of the units is via the green connector (CAN 1)
The power supply on CAN 2 is output only!
All FMS data (if available) are routed to the CAN 2 interface of the units.
CAN 2
Development
unit
Power supply for bordcomputer
Ignition
FMS-Daten (CAN)
Tacho data
Figure 23: Connection CAN 2 Development unit / Standard unit