Page 7.2
6-CHANNEL BATTERY SIMULATOR MODULE 41-752
pickering
SECTION 7 - MAINTENANCE INFORMATION
CALIBRATION PROCEDURE
The following calibration procedure provides a manual method of testing the 41-752 Battery Simulator for compliance
to its specification. The test is designed to ensure that the product is fully functional.
The procedure assumes the 41-752 is correctly installed in a suitable chassis and the soft front panel described in
this manual has been launched.
Required test Equipment
●
One or two DMM’s, 100µV or better resolution on DC voltage. Most 5½ digit DMM’s will meet the
requirement.
●
37-way D-Type connector assembly, recommended Pickering part 40-965-037
Test Procedure
Output Voltage Check
Connect a load to the output connector of the 41-752 module as shown in Figure 7.1.
Measure the voltage across the output terminals of the 41-752 module as below using a DMM, record the results
and check against the specification limit value.
Set Output Voltage
Measured Output
Voltage
Specification Limit ±0.2% ±20mV
Max
Min
1.0V
1.022
0.978
1.1V
1.1222
1.0778
1.2V
1.2224
1.1776
1.3V
1.3226
1.2774
1.4V
1.4228
1.3772
1.5V
1.523
1.477
1.6V
1.6232
1.5768
1.7V
1.7234
1.6766
1.8V
1.8236
1.7764
1.9V
1.9238
1.8762
2.0V
2.024
1.976
3.0V
3.026
2.974
4.0V
4.028
3.972
5.0V
5.03
4.97
6.0V
6.032
5.968
7.0V
7.034
6.966
