phytron IXEa-A Series, Руководство пользователя

Страница: 11 / 40

phytron
®
MA 1206-A001 GB 9
1.6 Safety Instructions
Read this manual and the device manual very carefully before installing and
operating the controller. Observe the safety instructions in this and the following
chapters.
Design, putting into service and maintenance may only be performed by qualified
and trained personnel.
These persons should be able to recognize and handle risks emerging from
electrical, mechanical or electronic components.
WARNING !
By persons without proper training and qualification, damages to devices or even
persons might result!
In case of motor voltages > 24 V:
The controller must only be operated if this unit and the motor housing both are
connected to protective ground.
If you need to open the device:
Up to 3 minutes after turning off the supply voltage, dangerous voltages may still
exist within the device.
Always switch off the supply voltage if you connect or disconnect any wires or
connectors at the controller. Most important:
Do not unplug any connector when powered!
Danger of electric arcing.
Voltages connected to the signal inputs and outputs should be safely separated
from mains. The maximum voltage against protective ground must not exceed
60 V
DC
or 25 V
AC
.
1.7 Control and Programming Instructions
•
For all programming instruction codes refer to the Programming manual MINILOG for
IXE
α
and SAM
α.
•
The line numbers are automatically assigned by the system.
•
Each line can receive several instructions with a maximum of 32 characters per line
•
The instructions must be separated by blank characters.
•
Do not insert extra blank characters within an instruction.