Phytec phyCORE-LPC2292/94, Руководство по оборудованию

Страница: 83 / 144

debugCORE-LPC2292/94
©
PHYTEC Messtechnik GmbH 2006 L-658e_5
71
The pinout of the 38-pin (0.64 mm pitch) Embedded Trace Macrocell
(ETM) and OCDS MICTOR connector at X800 is described below:
Pin Number Signal Description
1 /RESET Low-active reset signal. Can connected by
closing Jumper J800 (default open).
2, 3, 4 N.C. Not connected
5 GND Ground
6 TRACECLK Clock signal for trace port.
7, 8 N.C. Not connected
9 /RESET Low-active reset signal.
10 EXTIN0 External trigger input.
11 TDO JTAG signal test data out.
12 VTREF Can be connected to VCC (3.3 V) or GND
via Jumper J801 (default : VCC).
13 RTCK JTAG signal returned test clock output.
14 Vsupply Can be connected to VCC (3.3 V) or GND
via Jumper J801 (default : VCC).
15 TCK JTAG signal test clock.
16, 18, 20, 22 GND Ground
17 TMS JTAG signal test mode select.
19 TDI JTAG signal test data in.
21 /TRST JTAG signal test reset.
23, 25, 27, 29,
31, 33, 35, 37
N.C. Not connected
24 TRACEPKT3 Trace packet signal 3.
26 TRACEPKT2 Trace packet signal 2.
28 TRACEPKT1 Trace packet signal 1.
30 TRACEPKT0 Trace packet signal 0.
32 TRACESYNC Trace synchronization signal.
34 PIPESTAT2 Pipe Line status signal 2.
36 PIPESTAT1 Pipe Line status signal 1.
38 PIPESTAT0 Pipe Line status signal 0.
Table 43: ETM/OCDS Connector at X800