Phoenix Contact 2400184, Руководство пользователя

Страница: 7 / 16

VL PPC 3000
3386_en_C PHOENIX CONTACT
7/16
5 Installation
Depending on the configuration ordered, there are several
ways to mount the VL PPC 3000. Use the appropriate
section below to mount the VL PPC 3000.
When installing the VL PPC 3000 in a cabinet, follow these
general rules:
– Verify clearances within the cabinet. Typically, leave at
least 5 cm (2 in.) on each side with 12.7 cm (5 in.) on the
connector side if the VL PPC 3000 has the optional
optical storage drive.
– Drill all holes and make all cuts before beginning
installation. Be sure to protect already installed
components from shavings.
– Supporting panels must be at least 14 gauge to provide
proper support.
– Make sure that there is adequate space around the heat
sink (on the back of the VL PPC 3000) and air inlets and
outlets to provide sufficient cooling.
5.1 Panel mount
Panel mounts are the only valid mounting system for VL
IPCs with a display. This mounting system permits
installation of the VL PPC 3000 in a cabinet so the display
panel is visible on the outside (see Figure 1).
Conformance with EMC directives
Developed according to IEC 61000-6-2
IEC 61000-4-2 (ESD) Criterion B
IEC 61000-4-3 (radiated-noise immunity) Criterion A
IEC 61000-4-4 (burst) Criterion B
IEC 61000-4-5 (surge) Criterion B
IEC 61000-4-6 (conducted noise immunity) Criterion A
IEC 61000-4-8 (noise immunity against magnetic fields) Criterion A
EN 55022 (noise emission) Class A
Conformity
Conformity
c
Electromagnetic Compatibility Directive (EMC) 2004/108/EC
Approvals
Ordinary locations UL 508
Hazardous locations Class I, Div. 2, Groups A, B, C, D
NOTE:
Install the VL PPC 3000 with adequate clearance
around the heat sink to provide sufficient air flow
such that ambient temperatures do not exceed
the operating limits. Install cooling fan(s) in the
enclosure, if necessary.
NOTE:
Exceeding the system temperature limits can
result in performance degradation of any or all
components. It is therefore important that the
ambient temperature of the installation
environment is kept within the system
temperature limits of your VL PPC 3000.
Please be aware that adding PCI cards can add
heat to the system.
NOTE:
Connectors and switches must be accessible
from the rear. A wall panel thickness of at least
1.9 mm (14 ga.) is required for correct mounting
with IP65 protection.