VL PPC 3000
3386_en_C
PHOENIX CONTACT
13/16
5.
PCI card installation can be in slot 1 (see below), slot 0
or both.
For PCI slot 1:
a)
Remove the four Phillips-head screws (1) securing
the left side panel (2), and remove the panel.
Figure 10
Side panel and bracket removal
b)
Remove the retaining screw and washer (3)
securing the bracket (4). Remove the bracket from
the bracket frame (5).
c)
Line up the card’s connectors with the PCI slot
connector (6). Carefully push the card into the
connector. After it is fully inserted in the connector,
the card bracket should be aligned with the bracket
frame.
d)
Insert the retaining screw and washer (3)
previously removed and tighten to secure the card.
e)
Reinstall the left side panel (2) using the four
Phillips-head screws previously removed in
step a).
For PCI slot 0:
a)
Remove the two Phillips-head screws (1) holding
the bracket frame (2). Remove the bracket frame
and bracket (3) as an assembly.
b)
Remove the retaining screw and washer (4) and
remove the bracket from the bracket frame.
Figure 11
PCI slot 0 removal
Figure 12
PCI slot 0 card installation
When installing two cards of the same type,
drivers often assign higher priority to the card in
the lower slot number.
X10:COM
ERR
OR
RU
N
HDD
PWR
X7:USB
X6:USB
X5:USB
X4:USB
X9:DP++
X3:ETH
X2:ETH
X1:
PWR 24VDC
+
–
②
①
①
③
④
⑤
⑥
PCI Slot 1
X10:
COM
ERROR
RUN
HD
D
PWR
X7:USB
X6:USB
X5:USB
X4:USB
X9:DP++
X3:E
TH
X2:E
TH
X1: PWR 24VDC
+
–
①
②
③
④
⑤
PCI Slot 0
X10:
COM
ERROR
RUN
HD
D
PWR
X7:USB
X6:USB
X5:USB
X4:USB
X9:DP++
X3:E
TH
X2:E
TH
X1: PWR 24VDC
+
–
②
①
③
