9
To the power supply
!
Please note that the handset must be replaced before you
connect the machine to the power supply.
1
Plug the power connector into the back of the fax
machine. Plug the mains cable into the wall socket. The
machine will carry out an internal test. Afterwards you
need to enter the current time and date.
2
Use the dial pad to enter the correct time and date.
Confirm with
OK
.
Replacing the ink film
You cannot receive or copy documents unless an ink film is
loaded in the fax machine. For this reason an ink film for 50
pages has been inserted into your machine. The commercially
available ink film has a capacity of approx. 260 pages.
If the ink film is finished or if there is no ink film in the fax
machine, the red display lamp flashes, and the following mes-
sage appears:
refill inkfilm
1
Before loading a new ink film you must remove the
paper from the paper feed mechanism! Also follow the
instructions on your ink film packaging!
2
To obtain optimum quality, please use only ink films as
specified on your original roll. For safety reasons, do not
use any other brands because they can damage your fax
machine.
3
Open the machine by carefully lifting the operation
panel at the recess in the middle.
Removing the old ink film
1
Lift the rear ink film roll holding both sides with your index
fingers upwards, in order to remove it out of its seat and
place it next to the front ink film roll.
2
Remove both ink film rolls. They cannot be reused. Dispose
of the ink film rolls with normal waste. Load a new ink film,
because your fax machine cannot work correctly without it.
Loading the new ink film
1
Carefully remove the rubber rings from the new ink film. Take care
not to damage the ink film.
2
Lay the large roll in the grooves provided in the rear ink
film compartment.
