EN 74
3139 785 32804
Firmware Upgrading & Diagnostic Software
5.
Nucleus Name
DS_ASP_RemoteControl
Nucleus Number
1613
Description
This nucleus checks the interface to the remote control by having the user
confirm the key-code displayed.
At least one key must be tested.
If the user presses ‘a’ or ‘A’ the test is aborted. If the user presses ‘o’ or ‘O’ the
test is indicated as OK.
If the user holds down ‘PLAY’ for more than a second the test is indicated as
OK, if the user holds down ‘RECORD’ the test is indicated as failed.
Indicate the number of keys pressed to the user, both in the terminal logging
and on the display.
Technical
-
Initialise the display.
-
Display the key pressed by the user on the display.
-
Monitor the service port for an abort and get the next key pressed.
-
Update the display and repeat previous steps until user stops / confirms.
-
Display the number of keys that were pressed.
Execution Time
Depends on the user.
User Input
None
Error
Number
Description
161300
The test succeeded
161301
IIC-bus communication failed
161302
The user signals a failure of the remote control
161303
The user aborted the test
Example
DS:> 1613
161300: 4 keys were pressed.
Test OK @
Nucleus Name
DS_ASP_LEDsOn
Nucleus Number
1614
Description
Switches on the display leds.
Technical
ASP specific
-
Check if the analogue board is a MOBO board, if so:
-
Read the ASP pio port.
-
Set the RECORD-LED bit on in this port.
-
Write the ASP pio port.
-
Read the ASP pio port.
-
Set the TRAY-LED bit on in this port.
-
Write the ASP pio port.
-
Read the ASP pio port.
-
Set the EPG-LED bit on in this port.
-
Write the ASP pio port.
-
Else
-
Set the RECORD-LED bit on.
-
Write the external ASP pio port.
-
Set the TRAY-LED bit on.
-
Write the external ASP pio port.
-
Set the EPG-LED bit on.
-
Write the external ASP pio port.
MCU Specific
-
Get the user input and capitalize it and check validity
-
Check which lights should be turned on
-
Write the command to the MCU
Execution Time
Less than 1 second.
User Input
None, Green or Red: Choose which colour of the bi-led should be lit with the
rest (only for OLAL22PREMIER variant)
Error
Number
Description
161400
Switching on the LEDs succeeded
161401
IIC-bus communication failed
161402
Invalid parameter
Example
DS:> 1614
161400:
Test OK @
http://www.jdwxzlw.com/?fromuser=华盛维修
家电维修资料网,免费下载各种维修资料