Philips BDL4245E/00, Руководство по обслуживанию

Страница: 4 / 183

4
 Keep the monitor out of direct sunlight and away from stoves or any other heat source.
 Remove any object that could fall into the vents or prevent proper cooling of the monitor’s electronics.
 Do not block the ventilation holes on the cabinet.
 Keep the monitor dry. To avoid electric shock, do not expose it to rain or excessive moisture.
 If turning off the monitor by detaching power cable or DC power cord, wait for 6 seconds before attach the
power cable or DC power cord for normal operation.
 To avoid the risk of shock or permanent damage to the set do not expose the monitor to rain or excessive
moisture.
 When positioning the monitor, make sure the power plug and outlet are easily accessible.
 IMPORTANT : Always activate a screen saver program during your application. If a still image in high contrast
remains on the screen for an extended period of time, it may leave an ‘after-image’ or ‘ghost image’ on the front
of the screen. This is a well-known phenomenon that is caused by the shortcomings inherent in the LCD
technology. In most cases the afterimage will disappear gradually over a period of time after the power has
been switched off. Be aware that the after-image symptom cannot be repaired and is not covered under
warranty.
Regulatory Information
CE Declaration of Conformity
MMD declare under our responsibility that the product is in conformity with the following standards.
 EN60950-1: 2001 (Safety requirement of Information Technology Equipment)
 EN55022: 2006 (Radio Disturbance requirement of Information Technology Equipment)
 EN55024:1998+A:2001+A2: 2003 (Immunity requirement of Information Technology Equipment)
 EN61000-3-2:2006 (Limits for Harmonic Current Emission)

EN61000-3-3:1995+A1: 2001+A2:2005 (Limitation of Voltage Fluctuation and Flicker) following provisions of
directives applicable.
 2006/95/EC (Low Voltage Directive)
 2004/108/EC (EMC Directive)
 93/68/EEC (Amendment of EMC and Low Voltage Directive) and is produced by a manufacturing organization
on ISO9000 level.
Federal Communications Commission (FCC) Notice (U.S. Only)
This equipment
ha
s been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his own
expense.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.