Philco PD 125 IQ, Руководство пользователя

Страница: 16 / 44

EN - 1
08/2015 Copyright © 2015, Fast ČR, a. s.
Water supply hose
Do not use an old supply hose or the hose from the previous dishwasher. Always only use a new supply hose.
If you intend to connect a hose that is new or that has not been used for a long time to the appliance, fl ush the
hose out with water before connecting it. Connect the supply hose directly to the water tap.
The pressure in the water pipes should be in the range from 0.03 MPa to 1 MPa. If the water pressure is higher
than 1 MPa, it is necessary to install a pressure
valve. After making the connection, open the water supply fully
and check that water is not leaking anywhere. For safety reasons, make sure to always turn off the water supply
at the end of every wash cycle.
NOTE:
Certain models of the appliance are supplied with an Aquastop safety valve. Dangerous tension may
occur when Aquastop is used. Do not cut off the Aquastop valve. Do not bend or turn it in any way.
Drain hose
The drain hose can be connected either directly into a separate drain outlet, or into a sink trap. When a fl exible
pipe (if available) is used, water may be drained directly into the drain via a pipe bent over the edge of the sink.
Also the connection may by a minimum of 50 cm up to a maximum of 110 cm from the fl oor.
WARNING!
If the drain hose is longer than 4 m, dishes may remain dirty. In such a case, neither the manufacturer
nor vendor take any responsibility.