Philco PD 1062 BiS, Руководство пользователя

Страница: 38 / 44

EN - 36
01/2016 Copyright © 2016, Fast ČR, a. s.
How to connect the safety supply hose
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.
Water pressure must be between 0.04 MPa and 1 MPa. If the pressure is below the
minimum consult our Service Department for advice
1. Pull the safety supply hoses completely out from storage compartment located at
rear of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
3. Turn water fully on before starting the dishwasher.
About the safety supply hose
The safety supply hose consists of the double walls. The hose’s system guarantees its intervention by blocking
the fl ow of water in case of the supply hose breaking and when the air space between the supply hose itself
and the outer corrugated hose is full of water.
WARNING!
A hose that attaches to a sink spray can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected and the hole
plugged.
How to disconnect the safety supply hose
1. Turn off the water.
2. Release the water pressure by depressing the pressure release button. This relieves water pressure and
protects you, and the room, from severe splashing. Unscrew the safety supply hose from the faucet.
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly
in place. If the water pipes are new or have not been used for an extended period of time, let the water run to
make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the
water inlet can get blocked and damage the appliance.
WARNING!
Please close the hydrant after using.
Positioning of the appliance
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate proper installation.
How to Drain Excess Water from Hoses
If the sink is 1000 higher from the fl oor, the excess water in hoses cannot be drained directly into the sink. It
will be necessary to drain excess water from hoses into a bowl or suitable container that is held outside and
lower than the sink.