Philco PD 1062 BiS, Руководство пользователя

Страница: 29 / 44

EN - 27
01/2016 Copyright © 2016, Fast ČR, a. s.
NOTE:
When following this procedure from step1 to step 2, the fi lter system will be removed; when
following it from Step 2 to Step 1, the fi lter system will be installed.
NOTE:
– Inspect the fi lters for blocking after every time the dishwasher has been used.
– By unscrewing the coarse fi lter, you can remove the fi lter system. Remove any food remnants
and clean the fi lters under running water.
NOTE:
The entire fi lter assembly should be cleaned once a week.
Cleaning the Filter
To clean the coarse fi lter and the fi ne fi lter, use a cleaning brush. Reassemble the fi lter parts as shown in
the fi gures on the last page and reinsert the entire assembly in the dishwasher, positioning it in its seat and
pressing downwards.
WARNING!
When cleaning the fi lters, don’t knock on them. Otherwise, the fi lters could be contorted and the
performance of the dishwasher could be decreased.
Caring of the dishwasher
The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Cleaning the door
To clean the edge around the door, you should use only a soft warm, damp
cloth.
To avoid penetration of water into the door lock and electrical components,
do not use a spray cleaner of any kind.
WARNING!
Never use a spray cleaner to clean the door panel as it may damage the door lock and electrical
components.
Abrasive agents or some paper towels should not be used because of the risk of scratching or
leaving spots on the stainless steel surface.