Philco PD 1062 BiS, Руководство пользователя

Страница: 26 / 44

EN - 24
01/2016 Copyright © 2016, Fast ČR, a. s.
NOTE:
* EN 50242: This programme is the test cycle. The information for comparability test in accordance
with EN 50242, as follows:
●
Capacity: 10 setting
●
Position Upper basket: upper wheels on rails
●
Rinse aid setting: 6
●
Pl:0.49w; Po:0.45w.
Turning on the appliance
Starting a cycle wash
1
Draw out the lower and upper basket, load the dishes and push them back. It is commended to load the
lower basket fi rst, then the upper one (see the section entitled Loading the Dishwasher).
2
Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid).
3
Insert the plug into the socket. The power supply is 220-240 V AC / 50 Hz, the specifi cation of the socket is
10A 250V AC. Make sure that the water supply is turned on to full pressure.
4
Open the door, press the ON/OFF Button, and the ON/OFF light will turn on.
5
Press the program Button , the wash program will be changed as follows direction:
Intensive->Normal->ECO->Glass->90Min->Rapid;
If a program is selected, the response light will light. Then close the door, press the Start/Pause button - the
dishwasher will start.
NOTE:
When you press the Start/Pause button while the dishwasher is running, the operating indicator
light will stop fl ashing, and a sound signal will be made every minute until you press the Start/
Pause button.
Changing the program...
Premise:
1
A cycle that is underway can only be modifi ed if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refi lled (see the section entitled “Loading the
Detergent”).
2
Press the Start/Pause button, the dishwasher will be paused and press the Program button for at least
3 seconds. The machine will be in standby state, then you can change the program to the desired cycle
setting (see the section entitled “ Starting a wash cycle. . .” ).
NOTE:
If you open the door during the wash cycle, the machine will pause. The program light will stop
blinking and the buzzer will mooing every minute unless you close the door. After you close the
door,the machine will keep on working after 10 seconds.
Forgot to add a dish?
A forgotten dish can be added any time before the detergent cup opens.