Philco PD 1062 BiS, Руководство пользователя

Страница: 14 / 44

EN - 12
01/2016 Copyright © 2016, Fast ČR, a. s.
NOTE:
If your model does not have any water softener, you may skip this section.
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form
on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt container specifi cally designed to eliminate
lime and minerals from the water.
Loading the salt into the softener
Always use the salt intended for use with dishwasher.
The salt container is located beneath the lower basket and should be fi lled as explained in the following:
ATTENTION!
– Only use salt specifi cally designed for the use in dishwashers! Every other type of salt not
specifi cally designed for the use in a dishwasher, especially table salt, will damage the water
softener. In case of damages caused by the use of unsuitable salt the manufacturer does not
give any warranty nor is liable for any damages caused.
– Only fi ll with salt just before starting one of the complete washing programs.
– This will prevent any grain of salt or salty water, which may have been spilled, remaining on
the bottom of the machine for any period of time, which may cause corrosion.
Open
A
After the lower basket has been removed, unscrew and remove the cap from the salt container – see
picture
1
.
B
Place the end of the funnel (supplied) into the hole and introduce about 1.5k g of dishwasher salt.
C
Full fi ll the salt container with water; it is normal for a small amount of water to come out of the salt
container – see picture
2
.
D
After fi lling the container, screw the cap tightly back clockwise.
E
The salt warning light will stop being after the salt container has been fi lled with salt.
F
Immediately after fi lling the salt into the salt container, a washing program should be started program.
Otherwise the fi lter system, pump or other important parts of the machine may be damaged by salty
water. This is out of warranty.
NOTES:
1. The salt container must only be refi lled when the salt warning light in the control panel
comes on. Depending on how well the salt dissolves, the salt warning light may still be on
even though the salt container is fi lled. If there is no salt warning light in the control panel
(for some Models), you can estimate when to fi ll the salt into the softener by the cycles that
the dishwasher has run.
2. If there are spills of the salt, a soak or a rapid program should be run to remove the excessive salt.