22
7.2. Replacing The Electronic Drive Unit
TC 600
The turbopump and the TC 600 must only be
disconnected from each other when the
turbopump is completely at rest and the TC 600
has been disconnected from the power supply.
➡
Switch off the turbopump, vent to atmospheric pressure
(see Section 4.3 .) and allow to cool as necessary.
➡
If necessary, remove the turbopump from the system.
Unsrew screws 8c (2 pieces) from the Electronic Drive
➡
Unit TC 600 and remove the TC 600 from the turbopump.
CAUTION
➡
Install the new Electronic Drive Unit TC 600 back onto the
turbopump and connect again.
Please take into account that after replacement
the standard operating parameters are always
pre-set.
If your application requires different
parameters, please modify accordingly.
CAUTION
Replacing the Electronic Drive Unit TC 600
8
Electronic Drive Unit TC 600
8c Screw (2 Stück)
8
8c
