Adjustment
67
13
.04
Changing the top feed roller on the flat-bed version
After being dismounted, feed roller
3
must be stored carefully!
Any minor damage to the roller has a negative effect on the sealing result!
Lock feed roller
1
with an Allen key (SW 4
)
by passing the Allen key from the right
through the hole in the post and turning feed roller
1,
until the Allen key clicks into place.
Loosen feed roller
2
with a spanner wrench and twist it out.
Pull off feed roller
3
and keep it in a safe place.
Slide the new feed roller onto the shaft, hold it tightly and screw feed roller
2
into place.
Remove the Allen key.
Set the clearance of the sonotrode to feed roller
3
as described in Chapter
13.06 Feed
roller clearance.
Check the position of the sonotrode with regard to feed roller
3
as described in Chapter
13.07 Position of the feed rollers
, and adjust it if necessary.
●
●
●
●
●
●
●
Fig. 13 - 01
99-054
2
3
1