Adjustment
66
13
Adjustment
13
.01
Notes on adjustment
All following adjustments are based on a fully assembled machine and may only be carried
out by expert staff trained for this purpose.
Machine covers, which have to be removed and replaced to carry out checks and adjust-
ments, are not mentioned in the text.
The order of the following chapters corresponds to the most logical work sequence for ma-
chines which have to be completely adjusted. If only specific individual work steps are
carried out, both the preceding and following chapters must be observed.
Screws, nuts indicated in brackets ( ) are fastenings for machine parts, which must be loose-
ned before adjustment and tightened again afterwards.
If not otherwise specified, the machine must be disconnected from the electric
and pneumatic networks for all adjustment work!
Danger of injury if the machine starts up accidentally!
13
.02
Tools, gauges and other accessories
1 set of screwdrivers with blade widths from 2 to 10 mm
1 set of wrenches with jaw widths from 7 to 14 mm
1 set of Allen keys from 1.3 to 10 mm
1 feeler gauge from 0.05 to 1.00 mm
1 spanner wrench for feed wheel (on machines with arm for overlapped seams)
13
.03
Abbreviations
TDC = top dead center
BDC = bottom dead center
●
●
●
●
●