Pfaff 3588-05/020, Инструкция по эксплуатации, Страница: 63 / 190

Input
63
Circle
To enter a circle, three points are necessary. The fi rst point is automatically the starting
points. The two missing points still have to be entered. A stitch length must be defi ned.
Circular arc
For the circular arc the same applies as for the circle, whereby the last point defi nes the end
of the circular arc.
Start sewing
This function is used to start sewing. All following sections are sewn until the thread trim-
ming function is selected.
or
Thread trimming
The thread is cut. The start sewing function must have been activated previously.
Standard stitch length
This function is used to defi ne the stitch length, which will be used predominantly in the pro-
gram. During sewing the standard stitch will be displayed in the status bar and can be alte-
red on the machine with the stitch alteration function, without changing into the program-
ming mode.
Stitch length
A stitch length is defi ned for a certain seam sector.
This stitch length is not displayed in the status bar during sewing and can only be altered in
the programming mode.
Stitch width
This function carries out a zig-zag motion with the jig drive on the base line. Here the stitch
length indicates the feed motion along the base line from needle penetration to needle pe-
netration and must be selected accordingly. The stitch width is carried out vertically to the
base line. The position of the zig-zag to the base line must also be defi ned. If the stitch width
function is to be switched off, the width must be entered as 0 . 0 .
Other functions
This function is used for the selection of more functions, see Chapter 11 . 02 . 04 Other func-
tions.
Insert block
This function is used to insert a marked block after the current position.