Pfaff 3588-04/020, Инструкция по эксплуатации, Страница: 78 / 196

Input mode functions
11 - 28
STANDARD STITCH LENGTH
Determines the stitch length predominantly needed in the program. The standard stitch
length is displayed in the status bar during sewing and can be changed at the stitch
length control on the machine without having to go into the programming mode.
STITCH LENGTH
Determines a stitch length for a certain seam section.
This stitch length is not displayed in the status bar and can only be changed in the
programming mode.
STITCH WIDTH
Performs a zig-zig movement of the sewing jig feed on a base line. Here, the stitch
length determines the feed along the base line from penetration point to penetration
point and has to be selected accordingly. The stitch width runs perpendicular to the
base line. The position of the zig-zag must be determined, too. To switch the stitch
width off, enter 0.0 as width.
CIRCLE
If you wish to enter a circle, you have to determine three points. The first point is
automatically the starting point. The two remaining points have to be entered. A stitch
length must be defined.
ARC
For the arc, the same applies as for the circle. The last point, however, determines the
end of the arc.
CURVE END POINT
Turns a curve point into a curve end point.
FLAP STOP
With this function the flap starting point is determined. The flap program will be cycled
from this point on.
Start sewing
(number key 7)
Starts the sewing operation. All following sections are sewn until the Thread trimming
function is selected.
Thread trimming (number key 8)
Trims the thread. The Start sewing function must have been active before.
Machine functions F2 (number key 9)
This function key accommodates machine functions. They are displayed in a menu where
they can be selected. All machine functions are assigned a relocation parameter with which
the function can be shifted 99 stitches before or after the current position.
1
2
3
4
5
6
7
1 2 3 4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 43
<- - - - >
1 - ZIG-ZAG
2 - SECONDARY TENSION
3 - REDUCED SPEED
4 - SPEED
5 - VARIABLE SEWING SLOT
.....