Pfaff 3588-04/020, Инструкция по эксплуатации, Страница: 37 / 196

Preparation
9 - 6
9
.06
Selecting a seam program
When changing to a different seam program, please make sure that the part
set (folder, pocket plate and sewing jig) correspond to the new seam program.
If the wrong combination of parts and seam program is used, the machine may
be damaged seriously!
●
Select INPUT mode by pressing the respective key.
Depending on the setting and configuration of the machine the displayed status
bar may be different from the following example.
Fig. 9 - 06
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
0 1
1 2 3 4 5 6 7 9 0
Enter
8
Esc
Clear
●
If required, press right arrow key to go to parts program number selection.
●
Select a previously entered parts program using the number keys .
●
Confirm the selection by pressing Enter .
It is possible to transfer seam programs from a disk to the machine memory.
To do this, a disk drive must be connected (see chapter 8.06 Connecting a
disk drive ) and the READ/WRITE PROGRAM function must be selected (see
chapter 11.05 Functions in the INPUT mode ).
If you want to create a seam program on the control panel, use the CREATE/
MODIFY PROGRAMM function (see chapter 11.05 Functions in the INPUT
mode ).
0 1
Enter
Fig. 9 - 07
●
Activate the program station in which the seam program to be selected is to be stored
(number key 1 or 2).
●
Select the Program number selection
function (number key 3).
●
Select a previously entered seam program using the number keys .
PROGRAM NO. : 1000 PARTPROG. NO. : 0
[ PERMISSIBLE 0 - 9999 ]
or
to
to