14
Standards Compliance
In this manual, ‘AS2201.1’ refers to AS/NZS 2201.1:2007, ‘AS2201.5’ refers to AS/
NZS 2201.5:2008 and ‘AS2201’ refers to the current issues of the AS2201 range of
documents.
In order to achieve compliance with AS2201.5, the terms of the current issue of the
document ‘Permaconn AS/NZS 2201.5:2008 Compliance Statement’ must be met.
Note that the overall alarm transmission system configuration needs to comply with
AS2201.1 and AS2201.5.
It is stressed that the supervised premises alarm panel is be installed and maintained in
order to meet Class (as relevant to the alarm transmission system classification) under
AS2001. The logbook required under Clause 6.4 of that Standard is to remain current.
The monitoring centre is to hold a copy of the documentation required at AS2201.5
Clause 2.3.
The monitoring centre is to maintain ‘fault and maintenance logs’ in accordance with
AS 2201.5 Clause 3.9.on.
Subject to the Standard Terms and Conditions set out on the Activation Form for this
unit.
INSTALLATION MUST BE CARRIED OUT BY SERVICE PERSONNEL ONLY
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCOR-
RECT TYPE. DISPOSE OF USED BATTERIES.
For correct operation the unit must be powered with an approved power supply and a
12V/1.2AH sealed lead acid battery.
The unit must only be operated with the supplied antenna. Install the Permaconn
PM1030 in a location that no person[s] is closer than 200 mm to the antenna at all
times.
Australian Standard AS2201 requires regular service by qualified and licensed techni-
cians and regular testing.
The unit must be installed in accordance with this manual and AS2201.1 for proper
operation.
Liability
Warning
While every effort has been taken to ensure the accuracy of this document, RDCCO Pty Ltd assumes no
responsibility or liability for any errors or omissions. RDCCO Pty Ltd reserves the right to make changes
to this manual due to ongoing development.
RDCCO_2143_E_IN
PM1030 Manual March 2019 v2.2