11
Introduction
RCS Climbing Device and Hydraulics
Assembly Instructions
Product-Specific
Operations
The contractor must ensure that the
assembly, modification, dismantling,
moving, use and handling of the product
is managed and supervised by qualified
personnel and authorised personnel.
All persons working with the product
must be familiar with the operating
instructions and safety information.
The contractor has to ensure that the of-
ficial Assembly Instructions, Instructions
for Assembly and Use, other instructions
required for operations or assembly,
relevant planning documents, parts lists
and other data are available to the users.
Access ways and working areas
Safe access to all working areas must
be guaranteed at all times.
Working areas must remain free of any
tripping hazards.
Working platforms are to be kept clean
and tidy.
Avoid installing working areas and
access points in areas of risk.
Make sure the Hydraulic Pump is
positioned on a level and sufficiently
load-bearing surface.
Assembly
Mandatory personal protective
equipment (PPE):
– safety helmet
– safety shoes
– protective gloves
There is always the possibility of unfore-
seen risks arising during assembly work.
Assess the degree of risk in each individ-
ual case and, if necessary, take meas-
ures to prevent or at least minimise the
risk.
If guardrails cannot be used due to
technical reasons or have to be removed,
then site personnel are to be secured by
other means (e.g. through rope protec-
tion).
Site personnel are forbidden to remain
in areas below where assembly work is
being carried out unless the area of risk
has been provided with sufficient protec-
tion against falling, overturning, sliding
or rolling objects and masses. The area
of risk is to be cordoned off and clearly
marked.
Risk of crushing!
Do not touch if the load is moving!
Safety Instructions