http://www.pepwave.com
42
Copyright @ 2014 Pepwave
WAN Port
– 5
MSS
This setting should be configured based on the maximum payload size that the local system can
handle. The MSS (Maximum Segment Size) is computed from the MTU minus 40 bytes for TCP
over IPv4.
If MTU is set to Auto, the MSS will also be set automatically.
By default, MSS is set to
Auto
.
MAC Address
Clone
This setting allows you to configure the MAC address.
Some service providers (e.g. cable providers) identify the client’s MAC address and require the
client to always use the same MAC address to connect to the network. In such cases, change
the WAN interface’s MAC address to the original client PC’s one via this field.
The default MAC Address is a unique value assigned at the factory. In most cases, the default
value is sufficient. Clicking the Default button restores the MAC Address to the default value.
VLAN
Click the square if you wish to enable VLAN functionality and enable multiple broadcast domains.
Once you enable VLAN, you will be able to enter a name for your network.
Reply to ICMP
PING
If this field is disabled, the WAN connection will not respond to ICMP PING requests.
By default, this is
enabled
.
Additional
Public IP
Address
The IP Address List represents the list of fixed Internet IP addresses assigned by the ISP, in the
event that more than one Internet IP addresses are assigned to this WAN connection.
Enter the fixed Internet IP addresses and the corresponding subnet mask, and then click the
Down Arrow button to populate IP address entries to the IP Address List.
