PPP configuration task list
276
IPLink Software Configuration Guide
25 • PPP configuration
Mode:
subscriber ppp <subscriber>
Disable interface IP address auto-configuration from PPP
This procedure enables/disables automatic configuration of the interface IP address from the PPP network
control protocol negotiation.
Mode:
profile ppp
Configuring a PPPoE session
PPP can run over Ethernet (PPPoE). The active discovery protocol identifies the PPP remote peer on the Ether-
net and establishes a PPPoE session with it. The PPPoE session provides a logical point-to-point link that to
runs PPP as if it was a physical point-to-point link (e.g. a serial link).
This procedure describes how to configure an Ethernet port and a session for PPPoE
Step
Command
Purpose
1
[
name
] (subscr)[
subscriber
]# [no] timeout on-
timer
<timer>
Enables/disables forced reconnect every time
the timer
<timer>
expiries.
Step
Command
Purpose
1
[
name
] (pf-ppp)[no]# [no] local-address-
autoconfig
Enables/disables autoconfiguration of the local
IP address from PPP. Default:
enabled
.
Содержание IPLink Series
Страница 309: ...309 Appendix B Mode summary Chapter contents Introduction 310...
Страница 312: ...Introduction 312 IPLink Software Configuration Guide B Mode summary...
Страница 325: ...325 Appendix D Internetworking terms acronyms Chapter contents Abbreviations 326...
Страница 330: ...330 Appendix E Used IP ports in the IPLink software Chapter contents Used IP ports in the IPLink software 331...