PASI Polares 32, Руководство пользователя

Страница: 26 / 62

POLARES 32 21
Errore. Per applicare Heading 1 al testo da visualizzare in questo punto, utilizzare la scheda
Home.
Session, Electrodes, Measurements and Electrical Parameters. The display of the four
windows is controlled by the two buttons “>>” and “<<” as it was for the display of the
templates. Some of the parameters presented for the measurement session can be changed
by the operator, other parameters are fixed and cannot be changed.
The actual execution of the measurements must be performed on the “Session:
Measurements” window (this is the window on which it is placed after the switch to the
measurement session has been commanded).
To perform all measurements in sequence, the steps that need to be performed are as
follows.
•
Select the check box “Select all measurements”, all measurements in the table
below will be selected;
•
deselect the check box “Step: one measurement”;
• press “Perform measurements”.
The system will proceed with the sequential execution of all the measurements,
controlling the multiplexers and collecting the electrical values measured, displaying the
results as they are obtained on the window table.
The functions in this window are described in detail in section 4.3.4.
Displaying and continuing a measurement session
At the end of the execution of the measurement session, and after returning to the system
homepage by pressing the “Return and save” button, it is possible to view the session file
and possibly repeat the measurements. To do this, press the “Measurement Sessions”
button.
From the window, the measurement session file of interest must be selected and pressing
the “OK” button will proceed to display the session. This mode of opening session files
can be used for any type of session, whether no measurements have been taken, completed
or partially completed.