Partlow MRC 7800, Инструкция по установке, монтажу и эксплуатации.

Страница: 18 / 57

P
AGE
18
Configuration Introduction 4.1
After completing installation of the unit, the configuration procedures contained within this
section must be performed to prepare the unit for operation on the intended application. The
procedures include selecting specific parameters, entering data and possible jumper position-
ing.
Parameter selections and data entry are made via the front keypad. To ease configuration
and operation, user entered data has been divided up into several modes. Each mode
contains a different type of data or may be used for specific operating functions. For two pen
instruments, each mode is common to both pens. These modes are as follows:
Mode Display Code Function Description
Off oFF Operation Alarm Outputs off, Totalization off
Operation oPEr Operation Operation
Program Prog Configuration Configure operating parameters
Alarm Set ASEt Configuration Set alarm settings
Data logger dLS Configuration Adjust/set real time and log time
Setup
Data logger dLd Operation View logged data
Display
Preset PSA Operation Adjusts, sets preset values
Adjust
Test tESt Service Perform unit tests
Calibration CAL Service Perform unit calibration
Enable Enab Configuration Lockout or enable access to any
mode
Associated with each mode is a series of unique displays which are accessed via the front
keypad.
Prior to first time operation of the unit, the configuration procedures for the Program, Preset
Adjust, Data logger Setup, and Alarm Set modes must be performed as applicable.
Calibration and Test modes are not used as part of the unit configuration or operation. These
are used for service and maintenance functions and are discussed in detail in Section 5.6 of
this manual (page 40).