Paradyne FrameSaver NP 110, Руководство пользователя

Страница: 170 / 175

Appendix
980-001-0240B FrameSaver NP 110 User’s Manual - Installation Guide A-13
November 2000
V54 User Lp to Netw Loopback is in place at the User Port toward the Network Circuit, in response to a
V.54 LoopUp code from the Network (only if DS0s are assigned to the User Port.)
Line Lp to DSX Full T1 Line Loopback in place toward the DSX Circuit.
Payld Lp to DSX Full T1 Payload loopback in place toward the DSX Circuit.
QRSS to DSX Full T1 QRSS pattern BERT is being sent toward the DSX Circuit.
DSX 2047 to Netw 2047 pattern BERT is being sent toward the Network Circuit (for DS0s assigned to
DSX Port @ Nx56K.)
DSX Zero to Netw All Zeros pattern BERT is being sent toward the Network Circuit (for DS0s assigned
to DSX Port @ Nx56K.)
2047 to DSX 2047 pattern BERT is being sent toward the DSX Circuit (for DS0s assigned to DSX
Port @ Nx56K.)
DSX Lp to Netw Loopback is in place at the DSX Port (for DS0s assigned to DSX Port @ Nx64K)
toward the Network Circuit.
DSX CFA/Red Alarm Detected loss of DSX Circuit Facility. Framing must be enabled for DSX.
DSX Rmt/Yellow Alarm Carrier alarm notification that Transmit failure from this DCE has been detected on
this DSX Circuit Facility. Framing must be enabled for DSX.
DSX AIS/Blue Alarm Carrier alarm notification that an upstream signal failure has been detected on this
DSX Circuit Facility. Framing must be enabled for DSX.
Lp to Drop Loopback is in place at the Drop Port toward the Drop Circuit.
Drop Lp to Netw Loopback is in place at the Drop Port toward the Network Circuit.
Drop 2047 to Netw 2047 pattern BERT is being sent toward the Network Circuit (for DS0s assigned to
Drop Port).
Drop Zero to Netw All Zeros pattern BERT is being sent toward the Network Circuit (for DS0s assigned
to Drop Port).
2047 to Drop 2047 pattern BERT is being sent toward the Drop Circuit.
V54 Drop Lp to Netw Loopback is in place at the Drop Port toward the Network Circuit, in response to a
V.54 LoopUp code from the Network (only if DS0s are assigned to the Drop Port.)
LL to Drop Loopback is in place at the Drop Port toward the Drop Circuit, in response to an LL
(Local Loopback) signal at the Drop Port interface (only if DS0s are assigned to the
Drop Port.)
Single Flash Fail Failure of one of the unit’s two Flash Memory modules detected by the unit.
SEEPROM Failure Failure of SEEPROM hardware detected by the unit.
Netw Threshold Alarm Network Link Error Threshold (Data Frame Error Seconds) reached or exceeded.
DS0s must be assigned to the User Port.
User Threshold Alarm User Link Error Threshold (Data Frame Error Seconds) reached or exceeded. DS0s
must be assigned to the User Port.
Table A-13 System Test/Fault
Display Description