5 Diagnostics
980-001-0240B
FrameSaver NP 110 User’s Manual - Installation Guide
5-39
November 2000
8.
Select the “SNMPOperatorID” object. Enter the operator ID and choose SET.
Note: A value must be entered.
9.
An SNMP session should have been established in Step 8. To verify that a
session was established, perform a GET on the “SNMPSetStatus” object. If a
value of “active” is returned, a session was established. If a value of “passive” is
returned, a session was not established. If so, perform a GET on the
SNMPSetExecutionStatus object to determine the reason access was denied.
10. You can now access any SNMP object in the FrameSaver NP 110 MIB and
perform a SET on the object, including objects in the Config, ResetStats and
TimeEventCmd groups. However, once you configure all the objects within a
group, you must return to the SnmpSetCtl group and set the SNMPSetExecution
object to “accept.”
Note: You can only configure one group at a time.
11. To verify that the new settings of a group were accepted, you must do a GET on
the “SNMPSetExecutionStatus” object. If the SET was successfully executed,
this object will return nothing. If an error message is returned, the new settings
were not accepted.
12. To terminate the SNMP login session prior to inactivity logout, enter an incorrect
password in the SNMPUserAccessPassword and choose SET.
13. Confirm that the session has been terminated by performing a GET on the
“SNMPSetStatus” object. A value of “passive” should be returned.
Содержание FrameSaver NP 110
Страница 17: ...1 Preface 1 6 FrameSaver NP 110 User s Manual Installation Guide 980 001 0240B November 2000 ...
Страница 107: ...5 Diagnostics 5 40 NetPath 110 User s Manual Installation Guide 980 001 0240B November 2000 ...
Страница 175: ...Appendix A 18 FrameSaver NP 110 User s Manual Installation Guide 980 001 0240B November 2000 ...