Paradyne FrameSaver NP 110, Руководство пользователя

Страница: 123 / 175

6 Options
6-16 FrameSaver NP 110 User’s Manual - Installation Guide 980-001-0240B
November 2000
User Ckt Status
NOTE: The following fields appear only if the DSX port’s framing is set to ON.
DSX Port Fault - Displays highest priority fault: DSX CFA/Red Alarm, DSX Rmt/
Yellow Alarm, DSX AIS/Blue Alarm, DSX Threshold Alarm.
Drop Port - Displays the state or activity for the interface.
RTS: State of RTS lead, when Power is being detected from the DTE.
States are: ON or OFF.
DTR: State of DTR lead, when Power is being detected from the DTE.
States are: ON or OFF.
LL: State of LL lead, when Power is detected from the DTE.
States are: ON or OFF.
Table 6-4 Test Modes
DSX Drop Description
Clear Clear Terminates operator or externally-initiated Loopbacks,
BERT, and Test Packet tests.
DSX Lp to Netw Loops the DSX Ckt DS0s (@ Nx64K) toward the Network.
Drop Lp to Netw Loops the Drop Port back toward the Network.
DSX 2047 to Netw
DSX Zero to Netw Directs the indicated BERT pattern (in the DSX circuit’s
DS0s @ Nx56K) toward the Network.
Drop 2047 to Netw
Drop Zero to Netw Directs the indicated BERT pattern (in the Drop circuit’s
DS0s) toward the Network.
Line Lp to DSX Full T1 line loopback toward the DSX Port.
Payld Lp to DSX Full T1 payload loopback toward the DSX Port.
Loop to Drop Loops data back toward the Drop Port
QRSS to DSX Directs Full T1 QRSS BERT pattern toward the DSX
circuit.
2047 to DSX Directs a 2047 BERT pattern (in the DSX circuit’s DS0s @
Nx56K) toward the DSX circuit.
2047 to Drop Directs a 2047 BERT pattern toward the Drop circuit.
NOTES:
1. All Drop Port Loops and BERTs are at the current Drop Port configured data rate (56 or 64 kBps.)
2. Only one BERT may be active at a time. The results are a count of the number of Blocks Sent, Blocks
Errored, Block Error Rate and the duration of the test, displayed as shown on the example screen
above. When the BERT duration reaches the maximum count of 99:59:59, all counts freeze until
cleared or reset by the operator (the BERT data however, continues to be sent).