Paradox Spectra 1759EX V1.0, Справочное и монтажное руководство

Страница: 25 / 60

S
PECTRA
1759EX
23
6.1.2 D
ELETING
A
SSIGNED
W
IRELESS
T
RANSMITTERS
Sections [601] to [608]
6.1.3 P
ROGRAMMING THE
Z
ONES
The zones allocated to the wireless transmitters must be programmed. Refer to Zone Programming on page 16 for
more information.
6.2 VIEWING THE WIRELESS TRANSMITTER SIGNAL STRENGTH
Sections [631] to [638]
Once wireless transmitters have been installed and assigned to the Spectra 1759EX, the signal strength of each transmitter can
be verified in sections [631] to [638]. Each section represents the signal strength viewer for a specific device. For example,
section [631] is the viewer for the device in section [601] and section [638] is the viewer for the device in section [608]. Please
note that this feature only works with wireless transmitters assigned to an Expansion Input (zone) as described in section 6.1.1 on
page 22. A reading of 1 is the weakest and a reading of 8 is the strongest. An average reading of 3 and up is acceptable.
Sometimes moving the transmitter or control panel by a small amount will greatly increase the signal reception.
After entering the desired section, ignore the first reading as it will not be accurate.
You can also use a beep sequence feature to verify a transmitter’s signal strength. When you press a transmitter’s tamper switch,
beep tones emanating from all the keypads connected to the communication bus will advise you of the transmitter’s signal
strength.
This feature cannot be used with any remote controls assigned to the control panel.
6.3 SERIAL NUMBER DISPLAY
Section [630]
This feature will display the serial number of any wireless transmitter on any Spectra keypad.
How Do I Delete Assigned Wireless Transmitters?
1)
Press the [
ENTER
] key.
2) Enter your [
INSTALLER CODE
].
3) Enter the desired [
SECTION NUMBER
] (from sections [601] to [608]).
4) Press the [0] key six times to clear the serial number.
How Do I View a Wireless Transmitter’s Signal Strength?
1)
Press the [
ENTER
] key.
2) Enter your [
INSTALLER CODE
].
3) Enter the desired [
SECTION NUMBER
] (from sections [631] to [638]).
4) Press the transmitter’s tamper switch or open the corresponding zone.
5) On an LED keypad: The keypad will illuminate numbers 1 to 8.
On an LCD keypad: The keypad will display numbers from 1 to 8 on the screen. For example, the LCD screen below
shows a signal strength reading of 5.
How Do I Attain a Wireless Transmitter’s Signal Strength using the Beep Sequence?
1)
Press the [
ENTER
] key.
2) Enter your [
INSTALLER CODE
].
3) Enter the desired [
SECTION NUMBER
] (from sections [631] to [638]).
4) Press the transmitter’s tamper switch or open the corresponding zone.
5) Listen for the beep tones:
If the signal strength is less than 3 = One beep
If the signal strength is between 3 and 6 = Two beeps
If the signal strength is greater than 6 = Three beeps
How Do I View a Transmitter’s Serial Number?
1)
Press the [
ENTER
] key.
2) Enter your [
INSTALLER CODE
].
3) Enter the section [630].
4) Press the [0] key six times to clear the serial number.