Paradox Spectra 1759EX V1.0, Справочное и монтажное руководство

Страница: 24 / 60

22
R
EFERENCE
& I
NSTALLATION
M
ANUAL
5.9 ZONE SPEED
Sections [050] to [064]: Zones 1 to 15
001 to 255 X 10ms, Default = 600ms
The Zone Speed defines how quickly the control panel will respond to an open zone. The control panel will not display an open
zone on the keypad or generate an alarm until the programmed Zone Speed has elapsed. All other zone definitions and options
do not come into effect until the Zone Speed has elapsed. This feature prevents any momentary glitches from causing an alarm
or unnecessary reporting.
5.10 EOL ZONES
Section [132]: Zone Options
Option
[4]
OFF = Zones do not use EOL resistors (default)
Option
[4]
ON = Zones require EOL resistors
If all detection devices connected to the control panel have input terminals that require 1K
Ω
end of line resistors, enable option [4]
in section [132]. For details on using EOL resistors, refer to see Single Zone Inputs on page 9.
PART 6: WIRELESS ZONE PROGRAMMING
The Spectra 1759EX allows for the addition of up to eight fully supervised Omnia wireless transmitters, and up to eight programmable
remote controls.
6.1 WIRELESS TRANSMITTER PROGRAMMING
The programming of the wireless transmitters (detectors and door contacts) is accomplished in two steps:
1. Assign the wireless transmitter to the Spectra 1759EX.
2. Program the zones.
6.1.1 A
SSIGNING
W
IRELESS
T
RANSMITTERS TO THE
R
ECEIVER
Sections [601] to [608]
Sections [601] to [608] represent expansion inputs 1 to 8 respectively. For example, section [601] is assigned to
expansion input 1, section [602] is assigned to expansion input 2, etc. (refer to Table 6). Each Expansion Input
represents a specific zone in the Spectra 1759EX system (see Zone Recognition Table on page 16).
Do not assign detection devices from different modules to the same expansion input. For example, do
not assign a wireless transmitter to section [601] and then connect a detection device to input Z1 of the
APR3-ZX8.
The serial number is located on the inside of the transmitter or you can use the Serial Number Display (refer to
section 6.3 on page 23) to determine its serial number.
The transmitters must be activated once having been assigned to the Spectra 1759EX. To activate a
transmitter, insert the batteries and close the cover. To ensure proper synchronization between the control
panel and the transmitter, open and close the zone corresponding to the transmitter.
Table 6: Sections and Expansion Inputs
Section # 6-digit Serial Number Expansion Input
[601] ___/___/___/___/___/___ Input 1
[602] ___/___/___/___/___/___ Input 2
[603] ___/___/___/___/___/___ Input 3
[604] ___/___/___/___/___/___ Input 4
[605] ___/___/___/___/___/___ Input 5
[606] ___/___/___/___/___/___ Input 6
[607] ___/___/___/___/___/___ Input 7
[608] ___/___/___/___/___/___ Input 8
How Do I Assign Wireless Transmitters to the Spectra 1759EX?
1)
Press the [
ENTER
] key.
2) Enter your [
INSTALLER CODE
].
3) Enter the desired [
SECTION NUMBER
] (from sections [601] to [608]).
4) Enter the 6-digit [
SERIAL NUMBER
] of the wireless transmitter.