Pangolin Flashback 3 XE, Руководство пользователя

Страница: 48 / 56

Chapter 4
DMX and Standalone
This Appendix describes how to use the Flashback 3 in standalone mode and how
to control trough DMX-512.
Using LiveQUICK, you can specify a cue or sequence of cues to start playing
automatically upon power-up. The cue or sequence can play once or continuously.
Frames or animations are loaded into memory and played on demand using the
DMX-512 lighting standard. In addition to being able to select the frame or
animation, DMX can also control Image size, Position, Rotation angle, Playback
speed, Scan rate, Brightness, Color, and Write/Erase.
Standalone mode
If there is no DMX-512 signal present, and no connection to active LiveQUICK
program, the Flashback 3 SE will operate in Standalone mode.
In LiveQUICK, you can assign any cue to automatically start after the Flashback
3 SE is powered up.
NOTE: Standalone mode is disabled while the LiveQUICK Program is running.
When you exit the LiveQUICK program, Standalone operation will resume
automatically.
Optional DMX-512
Make sure that the dip switches have switch 0 set to "on". This switch enables the
DMX reception. Switches 1-9 control the DMX channel. For test purposes, we
will be using channel 1, so set the switch 1 to “on” and switches 2-9 to “off”.
Included with the evaluation kit is a short 4 pin DMX cable. You should connect
this cable to 5 pin XLR connector (or 3 pin XLR, if your DMX console uses 3 pin