When “Frame rate” is selected for “Transmission priority”
•
VGA: 64kbps - 4096kbps*
•
1280
´
960: 128kbps* - 8192kbps*
•
1600
´
1200: 256kbps* - 12288kbps
•
2560
´
1920: 768kbps* - 24576kbps*
When “VBR” is selected for “Transmission priority”
•
VGA: 64kbps - 12288kbps*
•
1280
´
960: 128kbps* - 12288kbps*
•
1600
´
1200: 256kbps* - 24576kbps*
•
2560
´
1920: 768kbps* - 24576kbps*
Note
•
The bit rate for “Stream” is restricted by “Bandwidth control(bit rate)” on the [Network] tab on the
“Network” page (
®
page 57). When a value with “*” attached is set, images may not be streamed.
•
When the refresh interval is short, the bit rate may go over the set value depending on the subject.
•
Depending on the number users connecting at the same time or the combination of features used, the
bit rate may be lower than the configured value. Check the transmission of images after changing
settings.
[Image quality]
Select the image quality of H.265 (or H.264) images from the following.
•
For “Frame rate”:
Motion priority/Normal/Quality priority
•
“VBR”:
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low
•
Default:
3
[Refresh interval]
Select an interval (I-frame interval; 0.2 - 5 seconds) to refresh the displayed H.265 (or H.264) images from the
following.
If using under a network environment with frequent error occurrences, shorten the refresh interval for H.265
(or H.264) to diminish image distortions. However, image refresh speed may be reduced or the refresh interval
may be longer than the set value.
0.2s/ 0.25s/ 0.33s/ 0.5s/ 1s/ 2s/ 3s/ 4s/ 5s
•
Default:
1s
[Transmission type]
Select the transmission type of H.265 (or H.264) images from the following.
•
Unicast port (AUTO):
Up to 14 users can access a single camera concurrently. “Unicast port1(Image)”
will automatically be selected when transmitting images from the camera. When it is unnecessary to fix the
port number for stream transmission such as when using in a particular LAN environment, it is
recommended to select “Unicast port (AUTO)”.
•
Unicast port (MANUAL):
Up to 14 users can access a single camera concurrently. It is necessary to select
“Unicast port1(Image)” manually to transmit images from the camera.
It is possible to fix the port number of the router used for stream transmission via the Internet by setting
“Unicast port (MANUAL)” (
page 57). Refer to the operating instructions of the router in use.
•
Multicast:
Unlimited number of users can access a single camera concurrently. Complete the entry field
of “Multicast address”, “Multicast port” and “Multicast TTL/HOPLimit” when transmitting stream with
multicast. Refer to page 8 for further information about the maximum concurrent access number.
•
Default:
Unicast port (AUTO)
Enter the unicast port number (used to transmit images from the camera).
34
Operating Instructions
2 Settings
