English
38
Volume Adjustment
Press <VOL +> <VOL -> or <+ (Unit)> <- (Unit)> to
adjust volume.
INPUT
MENU
ENTER
Unit
20
Volume (SPEAKERS)
●
The current sound volume level is memorised even if
the power is turned off.
●
When [Maximum VOL level] is set to [On], the volume
can only be adjusted to the maximum point you set,
and the displayed value turns red when it reached its
maximum. (see page 95)
●
When [Initial VOL level] is set to [On], the volume will
be at the set level when the display is turned on. (see
page 94)
Sound mute On / Off
It is useful when you want to mute the sound temporarily,
for example, when answering the phone or door.
Press <MUTE>.
●
appears on the screen and the sound is muted.
Press again to reactivate the sound.
●
It is also reactivated when the power is turned on / off
or the volume level is changed.
●
While MUTE is active, is displayed as a reminder
after operation.
●
In [ENGLISH(US)] OSD language, is displayed as
[MUTE].
Note
●
Displays the signal name as set in [Input label]. (see
page 82)
●
Input will not be switched unless [Input lock] is set to
[Off]. (see page 95)
●
Image retention (image lag) may occur on the LCD
liquid crystal panel when a still picture is kept on
the panel for an extended period. To prevent such
a problem, using the screensaver and wobbling is
recommended. (see page 81, 84)
RECALL
It is possible to check the setting status of input label,
picture mode, etc.
Press <RECALL>.
Current setting status will be displayed.
10:00
1
2
3
4
5
6
7
PC
16:9
Backup mode OK
AUDIO1 IN
Memory name: MEMORY2
Off timer
90 min
1
Input label
2
Aspect mode (see page 64)
3
Backup input change (see page 92)
4
Audio input (see page 94)
5
Profile name (see page 75)
6
Off timer remaining time (see page 39)
7
Clock / Mute (see page 38, 59)
●
The followings are displayed for about 30 seconds at
the end: [No signal] - when there is no video signal to
the selected input, [No external media] - when a USB
memory is not connected to the USB terminal at the
time of using the USB input.
During the OpenPort PLATFORM input, “no signal” is
not discriminated.
●
To display the clock, set [Date & time] in OpenPort
PLATFORM, and then set [Clock display] to [On].
(see page 59, 98)