Panasonic PT-RW630 series, Руководство по эксплуатации, Страница: 114 / 185

Chapter 4 Settings — [PROJECTOR SETUP] menu
114 - ENGLISH
13) Press
as
to select [CALIBRATION MESSAGE].
14) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ON] Messages are displayed during calibration.
[OFF] Messages are not displayed during calibration.
15) Press
as
to select [APPLY].
16) Press the <ENTER> button.
f
If the <ENTER> button is pressed with [CONSTANT MODE] in [BRIGHTNESS CONTROL SETUP] set to other than [OFF], the light
source brightness and white balance at the time is recorded as the standard brightness and white balance.
f
If the <ENTER> button is pressed while [LINK] is set between [GROUP A] and [GROUP D], the group name is displayed on the
screens of projectors that have been set in the same group.
LINK GROUP A
Note
f
When [CONSTANT MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] or [PC], keep the shutter function disabled (shutter:
open) for at least two minutes to perform the brightness sensor calibration after the [BRIGHTNESS CONTROL SETUP] setting has been
completed.
f
If the shutter function is enabled (shutter: closed) within approx. 10 minutes after the light source has turned on while [CONSTANT MODE]
in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] or [PC], brightness and color cannot be measured. Therefore, brightness may be
corrected approx. two minutes after the shutter function is disabled (shutter: open).
f
When the projector operates with [CONSTANT MODE] in [BRIGHTNESS CONTROL SETUP] set to [AUTO] or [PC], brightness and color
are not steady for approx. eight minutes after the light source has turned on. Therefore, brightness and color are measured automatically
approx. eight minutes after the light source has turned on. Based on the measured result, correction is performed so that the screen
brightness and color will be the same as the standard brightness and color that are adjusted with the brightness control.
f
When the projector operates with [CONSTANT MODE] in [BRIGHTNESS CONTROL SETUP] set to [AUTO] or [PC], the items of
[OPERATING MODE] and [LIGHT OUTPUT] cannot be changed.
f
When the projector operates with [CONSTANT MODE] in [BRIGHTNESS CONTROL SETUP] set to [AUTO], and [LINK] set to [OFF],
brightness will be corrected until it reaches [MAX LIGHT OUTPUT LEVEL].
f
The variation in brightness may increase due to dust accumulating on the lens, screen, or inside the projector, depending on the installation
environment of the projector.
f
When the variation in brightness has increased due to aging of the light source, or when you replaced the light source, readjust the
brightness control.
f
When the projector is used continuously for more than 24 hours, set the [CALIBRATION TIME] in [BRIGHTNESS CONTROL SETUP]. If it is
not set, correction will not be performed automatically.
f
The brightness control and dynamic contrast operate simultaneously, but the dynamic contrast does not operate while brightness and color
are being measured.
f
The [CALIBRATION TIME] setting will be reflected at the time when you enter the time.
f
The [CALIBRATION MESSAGE] setting will be reflected at the time when items are switched using
qw
.
Displaying [BRIGHTNESS CONTROL STATUS]
Display the brightness control status.
1) Press
as
to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f
The
[BRIGHTNESS CONTROL]
screen is displayed.
3) Press
as
to select [BRIGHTNESS CONTROL STATUS].
4) Press the <ENTER> button.
f
The [BRIGHTNESS CONTROL STATUS] screen is displayed.