Chapter 3
Basic Operations — Switching on/off the projector
ENGLISH - 67
7)
Press the <ZOOM> button to adjust the image size to match the screen.
8) Press the <FOCUS> button again to adjust the focus.
9)
Press the <ZOOM> button again to adjust the zoom and the image size to match the screen.
Note
f
When the projector is switched on for the first time after purchase, as well as when [ALL USER DATA] is executed from the [PROJECTOR
SETUP] menu
→
[INITIALIZE], the focus adjustment screen is displayed after projection starts, then the
[INITIAL SETTING]
screen is
displayed. Refer to “When the initial setting screen is displayed” (
x
page 60) for details.
Switching off the projector
1)
2)
1)
4)
3)
2)
1) Press the power standby <
v
> button.
f
The
[POWER OFF(STANDBY)]
confirmation screen is displayed.
2) Press
qw
to select [OK], and press the <ENTER> button.
(Or press the power standby <
v
> button again.)
f
Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights in orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights
up in red (fan is stopped).
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Attention
f
When switching off the projector, make sure to follow the procedures described. Failure to do so may damage the internal components and
result in malfunctions.
Note
f
For approximately 15 seconds after the projector is switched off, the indicator does not light up even if the power is switched on.
f
Even when the power standby <
v
> button is pressed and the projector is switched off, the projector consumes power if the main
power of the projector is on.
When the [PROJECTOR SETUP] menu
→
[STANDBY MODE] is set to [ECO], use of some functions is restricted, but the power
consumption during standby can be conserved.
