Chapter 4
Settings — [NETWORK] menu
172 - ENGLISH
5) Press
as
to select [STORE].
6) Press the <ENTER> button.
7)
When the confirmation screen is displayed, press
qw
to select [OK], and then press the <ENTER>
button.
Note
f
The projector does not support 10BaseT Full/Half.
When the projector is connected to a twisted-pair-cable transmitter
1) Press
as
to select [DIGITAL LINK SETUP].
2) Press the <ENTER> button.
f
The
[DIGITAL LINK SETUP]
screen is displayed.
3) Press
as
to select [DUPLEX(DIGITAL LINK)].
4) Press
qw
to switch the communication method.
f
The items will switch each time you press the button.
[100BaseTX-Full]
Sets full-duplex communication method.
[100BaseTX-Half]
Sets half-duplex communication method.
[AUTONEGOTIATION]
Sets the communication method automatically.
5) Press
as
to select [STORE].
6) Press the <ENTER> button.
7)
When the confirmation screen is displayed, press
qw
to select [OK], and then press the <ENTER>
button.
[DIGITAL LINK STATUS]
Display the DIGITAL LINK connection environment.
1) Press
as
to select [DIGITAL LINK STATUS].
2) Press the <ENTER> button.
f
The
[DIGITAL LINK STATUS]
screen is displayed.
[LINK STATUS]
One of [NO LINK], [DIGITAL LINK], [LONG REACH], or [ETHERNET] is displayed.
[HDCP STATUS]
One of [NO SIGNAL], [OFF], or [ON] is displayed.
[SIGNAL QUALITY]
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
f
[MAX]/[MIN]: Maximum/minimum value of the amount of error
f
Green (
-
12 dB or lower)
→
normal signal quality level.
f
Yellow (
-
11 to
-
8 dB)
→
caution level that noise may appear on the screen.
f
Red (
-
7 dB or higher)
→
abnormal level with interrupted synchronization and receiving not
possible.
[NETWORK SETUP]
Perform the initial setting of the network before using the network function.
1) Press
as
to select [NETWORK SETUP].
2) Press the <ENTER> button.
f
The
[NETWORK SETUP]
screen is displayed.
3) Press
as
to select an item, and change the settings according to the operation instructions of the
menu.
[PROJECTOR NAME]
Allows to change the projector name. Enter the host name if it is required to use a DHCP server.
