165
VQT2G62
Others
•
If you use commercially available external flashes with communication functions other than the
dedicated one, they may not operate normally or they may be damaged. Do not use them.
•
Even if the external flash is turned off, the camera may enter the external flash mode when the
external flash is attached. When you are not using the external flash, detach it.
•
When attaching the external flash, the built-in flash cannot be activated.
•
Do not open the built-in flash when an external flash is attached.
•
The camera will become unstable when attaching the external flash, it is recommended to use
a tripod when taking picture.
•
Turn off the camera when removing the external flash.
•
Detach the external flash when carrying the camera.
•
When attaching the external flash, do not hold only the external flash because it may detach
from the camera.
•
If you use the external flash when the white balance is set to [
] finely adjust the white
balance depending on the picture quality. (P79)
•
If you take pictures close to the subject in Wide, the vignetting effect may appear on the bottom
of the recorded picture.
•
Read the operating instructions of the external flash for details.
Using the Protector/Filter (optional)
The MC protector (optional) is a transparent filter which affects neither the colours nor the
amount of light, so it can always be used to protect the camera’s lens.
The ND filter (optional) reduces the amount of light to approximately 1/8th (equal to
adjusting the aperture value 3 increments) without affecting the colour balance.
PL filter (optional) will suppress the reflected light from a metal or non spherical surfaces
(flat non-metallic surfaces, water vapour or invisible particles in the air), making it possible
to take a picture with enhanced contrast.
Attach the filter.
Note
•
Do not attach multiple filters at the same time.
•
If the filter is tightened too much, you may not be able to remove it. Do not tighten it too much.
•
If the filter is dropped, it may be destroyed. Be careful not to drop it when attaching it to the
camera.
•
Be careful not to get a fingerprint, dirt, etc., on the filter when it is attached, otherwise the focus
may be adjusted to the lens, resulting in the subject being out of focus.
•
You can attach the lens cap or the lens hood when the filter is attached.
•
Refer to the instructions for each filter for details.
•
MC
u
“Multi-coated”
A
MC protector
B
ND filter
C
PL filter
DMC-GF1GN-VQT2G62_eng.book 165 ページ ２００９年８月２０日 木曜日 午前１１時７分
