99
VQT2G62
Advanced (Recording pictures)
•
The 20 mm/F1.7 interchangeable lens included in the DMC-GF1C utilises a lens drive system
to realise a compact and bright F1.7 lens. As a result, sound and vibration may occur during
focus operation, but this is not a malfunction.
•
Operating sounds will be recorded when Auto Focus is performed during Motion Picture
Recording. It is recommended to record with [CONTINUOUS AF] (P103) set to [OFF], if the
sound of operation bothers you
to avoid recording the lens noise
.
•
The 20 mm/F1.7 interchangeable lens included in the DMC-GF1C cannot be set to [AFC].
Note
•
The flash setting is fixed to [
Œ
].
•
Available recording time is displayed when the [REMAINING DISP.] (P130) in the [CUSTOM
MENU] menu is set to [REMAINING TIME].
•
Refer to P191 for information about the available recording time.
•
The available recording time displayed on the screen may not decrease regularly.
•
Depending on the type of the card, the card access indication may appear for a while after
recording motion pictures. This is not a malfunction.
•
The operational sound of the zoom or button operation may be recorded when it is operated
during the recording of a motion picture.
•
Audio will not be recorded for 0.5 seconds after it starts recording if it is kept pressed. Release
the motion picture button right after you press it.
•
The screen may be blacked out momentarily, or the unit may record noise due to static
electricity or electromagnetic waves etc. depending on the environment of the motion picture
recording.
•
When operating the zoom when recording motion pictures, it may take time to come into focus.
•
If The Extra Optical Zoom was used before pressing the motion picture button, those settings
will be cleared, so the focus range will change dramatically.
•
When the aspect ratio setting is different in still and motion pictures, the angle of view changes
at the start of motion picture recording. When [
REC AREA] (P130) is set to [
], angle of
view during motion picture recording is displayed.
•
The ISO sensitivity will be set to [AUTO] when recording motion pictures.
•
When recording motion pictures, [STABILIZER] (Only available when a lens that supports the
Stabilizer function is attached) is fixed to [MODE1].
•
When recording motion pictures, the following functions cannot be used.
–
[
] and [
] in [AF MODE]
–
Direction Detection Function
Start recording by pressing the motion
picture button.
A
Elapsed recording time
B
Available recording time
•
The audio is also recorded simultaneously from the
built-in microphone on this unit. (Motion pictures
cannot be recorded without audio.)
•
The recording state indicator (red)
C
will flash while recording motion pictures.
•
Press the shutter button halfway when it is difficult to focus on the subject.
•
You can also switch to Manual Focus by pressing [AF/MF] and selecting [MF] (P74).
Stop the recording by pressing the motion picture button again.
•
Sound will go off when pressing the motion picture button indicating start/stop of motion
picture recording.
Sound volume can be set in [BEEP] (P33).
•
If the card becomes full in the middle of recording, the camera stops recording
automatically.
B
C
A
DMC-GF1GN-VQT2G62_eng.book 99 ページ ２００９年８月２０日 木曜日 午前１１時７分
