Dial Number
Assigns a telephone or beeper number to Device 1, 2, or 3. The subscriber can also specify the number to be
dialed by entering it from his or her telephone, allowing the subscriber to set this feature on a case by case
basis.
Note
•
The callback number entry code "X" must be included in the number to be called if the "Beeper Callback
No. Entry Mode" is set to any value other than "Disable" and "Type of Device" is set to "Beeper". The
proper number of dialing pauses must be inserted before the callback entry code.
•
When the VPS calls a trunk (CO line) via a PRI (ISDN Primary Rate Access Interface) card of a
Panasonic PBX, please be sure to add "#" after the telephone number (1112223333 in the example
here):
Example: 9P1112223333#PP123PP456PPX# (P: Dial Pause)
Default
None
Value Range
Max. 32 digits consisting of 0–9, , # and special codes:
,
: Dial Pause (default 1 s)
;
: Dial Pause (default 3 s)
T
: Dial Tone Detection
X
: Callback Number Entry Code
0–9, , #
: Dial Codes
Programming Manual References
"Beeper Callback No. Entry Mode" in 2.1.4 Notification Parameters
Feature Manual References
2.2.32 Message Waiting Notification—Device
Type of Device
Specifies the type of device telephone or beeper that will receive message notification. The subscriber can
also specify the type of device from his or her telephone.
Default
Telephone
Value Range
Telephone, Beeper
Feature Manual References
2.2.32 Message Waiting Notification—Device
No. of Retries
Specifies the number of times the VPS will try to send notification if the device is busy or if there is no answer.
Document Version 3.0 2010/06
Programming Manual
57
2.1.4 Notification Parameters
