93
When configuring an Output-Type to “SDI,” the settings are almost the same like in section
“3.3.9.2 Input Settings.” Start with selecting Output-Type first.
Select an Output Module 1-8,
only available when Deltacast
Modules are installed (Picture
3.3.9.3.10).
When an NDI Output is created, a valid “Stream name” has to be entered in order to be identifiable
throughout the NDI-Network (Picture 3.3.9.3.11). In addition, the Video-Format needs to be specified.
Apart from individually specifying the Video-Format, NDI Output-Type settings are the same as
previously described in section “3.3.9.2 Input Settings.”
The “More…” button to the right of each output opens a pop-up window with
advanced output setup options (Picture 3.3.9.2.14).
“Output-Tab”:
The Output-Tab allows adding of an artificial
delay to the output signal for ST2110 & SDI.
Default is “0” (no additional delay) and the
maximum is 12 frames.
“ST2110-Tab”:
The ST2110-Tab provides all required Video &
Audio settings regarding the ST2110 Standard.
Click the “ ” symbol (which will turn into a green
check mark) in order to activate the “Video
and/or Audio IP” and “Port” settings for
adjustments. When finished, press the keyboard
“Return” or “Enter” key, or click on the green
symbol to confirm and close.
Enable or disable the individual Audio Group-1
and/or Audio Group-2 using the designated .
Note:
When the Output type is set to “SDI,” the “ST2110” tab will disappear from the “More” selection.
However, when the Output type is set to “Stream” instead, the former “ST2110” tab will be replaced with
the “RTP” tab.
Picture 3.3.9.3.8
Picture 3.3.9.3.9
Define Output connector Out 1-4
(Picture 3.3.9.3.11).
Picture 3.3.9.3.10
Picture 3.3.9.3.11
Picture 3.3.9.3.12
Picture 3.3.9.3.13
Picture 3.3.9.3.14
Picture 3.3.9.3.15
