RGB-OUT
POWER
8m
m
MAX
BATTERY
56
As
necessary
55
Installation
Wiring Connections
CY-TM100N
Notes:
¡
An FM radio antenna
should be kept away
from the electric-
magnetic wave
generators (e.g. GSM,
other antennas) .
¡
The use of an antenna
distributor may disturb
the TMC reception. In
that case, please
consult the shop where
you purchased this
unit.
¡
Carefully follow the directions given in the
installation manual when installing and wiring
the product. Incorrect wiring may lead to
accidents or fire or cause damage to the
product. When wiring, take care not to damage
the cords. Prevent them from getting caught in
the vehicle chassis, screws and moving parts
such as seat rails. Do not scratch the cord, pull,
bend or twist it, run it near a heat source or
place heavy objects on top of it. If it is
unavoidable to run a cord over a sharp metal
edge, protect the cord by winding it with vinyl
tape or another material.
¡
Make sure the cords do not interfere with
driving or getting in and out of the vehicle.
Bundle the cords together or attach them to
prevent them from impeding the steering wheel,
gear shift lever, brake pedal, the driver's feet
and anything else. Otherwise the cords may get
caught in moving parts such as the brake pedal
and gear shift lever and lead to accidents.
Warning
TMC Connector
CN-DV2300N
CY-TM100N
<FOR CN-DV1800EN>
Battery lead 3 m (Yellow)
TMC Cable
5 m (Black)
TMC Connector
The independent FM
radio antenna
(Not supplied)
FUSE 3 A
Not Used
To the car battery, continuous
+12 V DC
To clean, bare metallic part of
the vehicle chassis
Ground lead 2 m (Black)
To TMC Unit
¡
Remove the seal on the
TMC Connector.
¡
Reseal the Test connector at the
right of the TMC connector with
the protection seal
y
.
u
ISO Antenna
Adapter
(If needed)
Caution:
Be sure to insulate any exposed wires
to prevent short circuiting with the
car chassis. Bundle all cables, and
prevent cable terminals from touching
any metal parts.
ENG