This unit enables up to 100 settings for the camera direction (panning
and tilting), zoom, focus, iris, gain and white balance to be registered in
its preset memories, and called.
However, the number of settings that can be registered and called
depends on the type of wireless remote control or controller that is used
for operation.
• The focus and iris operating modes (manual and auto settings) are
neither registered nor recalled. The current focus and iris values are
registered.
• The focus and iris values can be recalled only when the manual
settings are applicable.
• For the white balance, the current White Balance Mode adjustment
values are registered. If a preset value is recalled when AWB A
or AWB B is selected, the adjustment value selected when it was
registered as a preset will be recalled. The R Gain and B Gain values
return to 0 in such cases.
<NOTE>
• When there is a large difference in the environmental temperature
between the time of registration and the time the setting is called,
displacement of the preset position may occur.
• If displacement occurs, perform registration again.
• When a manual operation is performed for pan, tilt, zoom, focus or iris
during preset recall, the preset operation for the pan, tilt, zoom, focus
or iris operation concerned will be aborted.
• If another preset has been recalled during an ongoing preset recall,
the preset being recalled is aborted, and operation for the preset called
last is performed instead.
When performing operations from a wireless
remote control
Twelve settings (preset No.1 to No.12) can be registered and called
using the wireless remote control.
The <1> to <12> buttons correspond to the unit’s preset memories No.1
to No.12.
Registering the settings in the preset memories
1.
Display the picture to be shot on the monitor.
Operate the pan, tilt or zoom buttons to determine the camera angle.
Adjust the focus, iris, gain and white balance if they need to be
adjusted.
2.
While holding down the <PRESET> button, press the
button corresponding to the preset memory number.
• If a preset memory number with an already registered setting has
been selected, the existing setting will be erased and replaced with
the new one.
Calling the settings of the preset memories
1.
Press the button in which the preset memory setting has
been registered.
When performing operations from a controller
When using an AW-RP50 or AW-RP120
Up to 100 entries can be registered/recalled.
For details, refer to the operating instructions for the controller.
When using an AK-HRP200
Preset memories cannot be registered or recalled.
Preset memories
30
31
